The firewall is now configured with a proper IP address to work in your LAN network, so go ahead and connect the cables:
To complete this step and apply changes to the device, click the Commit link at the top right:Īfter the commit completes, the browser eventually times out as the IP address has changed, so you'll need to manually change the address in the address bar to reconnect to the new IP. Next, select the Services tab and configure a DNS server.
Select Setup on the left pane, then select Management, where you can change the Management Interface Settings:Ĭhange the interface configuration and click OK.
#SETTING UP YOUR T5 WITH SPARKBOOTH PASSWORD#
Log in, using the default username and password admin / admin, then navigate to the Device tab. You can safely ignore the error message at this time, which then takes you to the login screen: This is because the certificate used by the web interface is a self-signed certificate your browser does not trust. When making your first connection to the web interface, your browser may display an error message. Now you need to reconnect to the new IP address -please skip to step 1.3. 55%.60%75%.99%.100%Īt this point, you'll lose SSH and SSL access to the device, as the IP address was changed and the management service restarted to adopt these changes. Use the commit command to apply the new settings to the commit Please change your password prior to configureĮntering configuration set deviceconfig system ip-address 10.0.0.10 netmask 255.255.255.0 default-gateway 10.0.0.1 dns-setting servers primary 4.2.2.2 Warning: Your device is still configured with the default admin account credentials. Using keyboard-interactive authentication. From here, we'll start setting up the proper IP address and subnet for the device, and the default gateway and DNS settings, so the unit can collect updates later. The default username and password are admin / admin, so we'll go ahead and log in to reveal the CLI. and the Graphical User Interface or GUI in step 1.2. We'll highlight the console and SSH in step 1.1. Remounting root filesystem in read-write mode: Īfter the device is booted, a login prompt is displayed in the console connection and SSH or SSL connections can be made to 192.168.1.1. Īfter preparing the cables and the workstation, plug the unit into an electrical outlet and watch the firewall boot up. If you use PuTTY, it should come with the appropriate configuration if connection type is set to Serial. When using a console cable, set the terminal emulator to 9600baud, 8 data bits, 1 stop bit, parity none, VT100. When using the management port, the workstation you'll be using must be reconfigured so its network interface has an IP address in the 192.168.1.0/24 IP range, as the default IP of the management port will be 192.168.1.1. The two methods available to connect to the new device is either using a network cable on the management port or an ethernet-to-db-9 console cable. The first thing you'll want to configure is the management IP address, which makes it easier to continue setting up your new device later on.
0 kommentar(er)
